AudioQuest Brave Heart Full-Range ZERO-Tech Speaker Cable (8', 2 x Male Multi-Spade, Silver)

• ZERO-Tech (No Characteristic Impedance): The only way to prevent characteristic-impedance mismatch-effects between a cable and its attached source and load circuits is for the cable not to have a characteristic-impedance. ZERO-Tech accomplishes this by eliminating any electrostatic field between the cable’s high and low signal conductors — enabling uncompressed current transfer. All-important transient current is unrestricted, and RF-Noise Dissipation is linearized (consistent octave to octave).
• Solid Perfect-Surface Copper+ (PSC+) Conductors: Solid conductors prevent strand-interaction, a major source of dynamic distortion. Extreme-purity PSC+ copper minimizes distortion caused by grain boundaries and maximizes RF-Noise Dissipation.
• Linear Noise-Dissipation: The Earth is permeated with RF-Noise from satellites, cellular, WiFi, etc. Brave Heart’s Graphene+Carbon Mesh-Network, ZERO-Tech, direction-controlled metal, 72v DBS, and silver-plated shield drains effectively minimize damaging RF-Noise.
• 72v Dielectric-Bias System (DBS) with RF Noise-Trap: Insulation is also a dielectric that acts like a shunt-filter. Biasing the dielectric both minimizes dielectric-noise and linearizes the filter, significantly improving wide-bandwidth dissipation of induced noise.
• Silver-Plated RF Shield Drains: Significantly aid in the efficient dissipation of RF-Noise.
• Permanent Molecular Optimization (PMO): By optimally and efficiently applying a high-frequency AC signal many times greater than any audio system could possibly provide over any length of time, transient intermodulation distortion and the cable burn-in process are significantly reduced.
• Cold-Welded Red-Copper Spades or Bananas: Cold-Welding avoids the introduction of heat and distortion-causing materials like solder. The bare parts are submerged (hung) in silver instead of tumbled in a lower-grade solution. Speaker breakouts and plug casings are synthetic, not metal, to avoid inducing RF Noise into the conductors.
• Directionality: All drawn metal strands or conductors have a non-symmetrical, and therefore directional, grain structure. AudioQuest controls the resulting RF impedance variation so that noise is drained away from where it will cause distortion. A fundamental aspect of AudioQuest’s multifaceted Noise-Dissipation technology, Direction-Controlled Conductors ensure induced noise is dissipated and drained properly.